In our quick guide we explain how to change the resin packs correctly and quickly. The video explains it perfectly in detail.
1. Check the mineral content of the water (value higher than 10 = change required)
2. Close water access
3. Disconnect the lower hose and open the tap to release the pressure from the system
4. Now remove the upper hose
5. Remove the lid (hold down the yellow lever)
6. Remove the resin pack and insert it in a circular motion until it is completely seated in the tank. (Stamping the tank on a surface also helps)
7. Close the lid
8. Connect the water supply (first the inlet at the bottom and then the outlet at the top)
9. Bleed the system (water will come out if bleed is successful)
10. Check the mineral content of the water
11. Done!
Please note the following order of the resin packs
For filters size S : 1 x green resin pack
For L and LC size filters : 1 x red resin pack at the bottom, 1 x red resin pack in the middle and 1 x green resin pack at the top.
Whether red or green, the contents of the resin packs are always identical. The colors are only used to help you insert the resin packs
